Skip to content
Home » News » Commissioning Of Cow Dung Drying Machine

Commissioning Of Cow Dung Drying Machine

Bluslot® Solid Liquid Separator

The solid-liquid separator is an equipment for dewatering cow dung in large and medium-sized cattle farms. After dehydration treatment of cow dung solid-liquid separator, the water content of cow dung is low, the water content is only about 50%, the appearance is fluffy, not greasy, the smell is reduced, the hands are squeezed, there is no water, and the hands are not caked. The treated dried cow dung can be used as bedding for cow bed or can be directly bagged or sold. The moisture content of treated cow dung is the condition for fermenting cow dung organic fertilizer.

Key Points Of Installation And Commissioning Of Cow Dung Drying Machine

  • First, turn on the main motor, run to determine whether the rotation direction of the screw shaft is correct, stop, then fill the discharge port of the machine with material slag or waste newspaper and cloth containing about 70% water, and then adjust the position of the heavy block to a large value.
  • Torque is applied to form the pressure layer of the extruder. The extruder without pressure layer cannot be opened because the discharge outlet is sprayed immediately after pumping manure without pressure.
  • Adjust the position to a large value. Torque is applied to form the pressure layer of the extruder. The extruder without pressure layer cannot be opened because the discharge outlet is sprayed immediately after pumping manure without pressure. Please fill in the unloading port! The use of extruder should be managed by a special person. The person in charge should understand the performance of the whole machine and should always maintain and maintain it. Generally, during normal use, it should be cleaned every two months.
  • When cleaning, first remove the bolts at the outlet, then take out the screw press screen, and clean the blockage in the mesh screen with water and copper wire brush. In particular, it should be noted that the original installation position of the screen should be maintained. At the same time, pay attention to the screen position of the screen. Mark and maintain the original position during installation. Otherwise, the wear of mesh will increase in future operation, which will naturally affect the extruder. Discharge efficiency.

Leave a Reply

Your email address will not be published. Required fields are marked *